Hex Wrench Storage - Makita XRJ01 Manual De Instrucciones

NOTE:
If you remove the saw blade without rotating the
•
blade clamp sleeve fully, the sleeve may not be
fixed. In this case, rotate the blade clamp sleeve
fully, then make the sleeve fixed at the released
position.
For Model XRJ04
3 4
1
2
014045
1
1. Recipro saw blade
2. Hex wrench
3. Hole for recipro saw blade
4. Blade clamp
014048
To install the saw blade, loosen the bolt by hex wrench.
When installing a recipro saw blade, press the bolt with
the hex wrench to open the slot during inserting the
blade.
1. Hex wrench
2. Bolt
3. Loosen
4. Tighten
1
1. Saw blade
2. Blade clamp
3. Hole for recipro saw blade
4. Hole for jig saw blade
014047
014086
You can use both jig saw blades (B type) and recipro
saw blades according to your work. Insert the saw blade
straight into the blade clamp and tighten it by hex
wrench. Pull the saw blade lightly to make sure that the
saw blade does not fall off during operation.
To remove the saw blade, follow the installation
procedure in reverse.

Hex wrench storage

2
014202
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
7
1. Hex wrench
2. Protrusion
1