Technical Data - sunjoe SJPPH48 Manual Del Operador

Technical Data

Heater Fuel Type ....................................... Liquid propane gas
Adjustable Heat Output .................. 25,000 BTU - 48,000 BTU
Coverage Area ...................................... 250 sq. ft. | 9 ft. radius
Runtime Max ............................................... High setting: 4 hrs
50% load per standard 20 lbs tank
Dimension ........................................... 32.85 in.(D) x 90.6 in.(H)
Propane Hose Length .......................................... 4.6 ft (1.4 m)
Injector Diameter ....................................... 0.846 in. (2.15 mm)
Manifold Pressure ................................................... 11 in. W.C.
Max Gas Supply ..................................... 250 PSI (1723.7 kPa)
Min Gas Supply ................................................. 5 PSI (35 kPa)
for Input Adjustment
Net Weight ....................................................... 28.7 lbs (13 kg)
Unpacking
NOTE: Before assembly, make sure that all of the parts and
hardware listed below are present. If any part is missing or
damaged, do not attempt to assemble the product. Contact
the Snow Joe + Sun Joe
® ®
1-866-SNOWJOE (1-866-766-9563).
Parts
1. Reflector center cap
3. Burner assembly
5. Lower pole
7. Cylinder tank
9. Wheel assembly
Hardware
A. M6x10 Phillips head bolt (12)
B. 6 mm plain washer (18)
C. M6 cap nut (15)
D. M6x70 reflector stud (3)
E. M6x14 Hexagon socket head bolt (8)
F. M5x12 pole screw (6)
G. M6x20 wheel screw (2)
(23.3 m | 2.7 m radius)
2
Low setting: 7 hrs
(83 cm x 230 cm)
customer service department at
2. Reflector panel (4)
4. Upper pole
6. Deck ring
8. Cylinder securing wire
Assembly
Tools Required (Not included):
• Adjustable open end wrench
• Phillips screwdriver
Choose a soft and level location for assembly. Remove all
parts from the packaging, and check for missing parts.
1. Line up holes on the bracket of the wheel assembly with
the corresponding holes on the base of the cylinder tank,
then insert the M6x20 wheel screws (G) through holes and
tighten to secure. Be sure the wheel assembly is parallel
to the base (Fig. 1).
Hardware Required
ITEM
G
Wheel screw (M6x20)
Fig. 1
2. Place the lower pole in the middle of the bar table, fix with
4 M6x14 hexagon socket head bolts (E). Slide the deck
ring down the lower pole to cover the connection part and
the bolts (Fig. 2).
Hardware Required
ITEM
E
Hexagon socket head bolt (M6x14)
4
DESCRIPTION
Cylinder tank
Wheel assembly
Wheel screw
(M6x20)
DESCRIPTION
QTY.
2
QTY.
4