sunjoe SJPPH48 Manual Del Operador página 6

6. Attach the reflector assembly to the burner assembly.
Place a plain washer (B) over the threaded end of each
reflector stud (D) sticking out through reflector assembly
and secure with cap nuts (C). Note: Do not overtighten
(Fig. 6).
Hardware Required
ITEM DESCRIPTION
B
Plain Washer (6 mm)
C
Cap nut (M6)
Fig. 6
Reflector
assembly
Burner
assembly
7. Insert the propane hose that is connected with the burner
assembly into the upper pole. Secure with 4 M6x14
hexagon socket head bolts (E) (Fig. 7)
Hardware Required
ITEM DESCRIPTION
E
Hexagon socket head bolt (M6x14)
Burner
assembly
Propane
hose
Upper
pole
8. Connect the upper pole assembly with the lower pole
assembly as shown. Fix with 6 M5x12 pole screws (F)
(Fig. 8).
QTY.
3
3
Cap nut
Plain washer
Reflector stud
9. Fill sand into the cylinder tank base through the hole in the
QTY.
4
Fig. 7
10. Insert the ends of the cylinder securing wire into the two
Hexagon socket
head bolt
(M6x14)
6
Hardware Required
ITEM DESCRIPTION
F
Pole screw (M5x12)
Upper pole
assembly
Lower pole
assembly
middle, as shown (Fig. 9).
NOTE: Purchase sand separately at your local garden
center or hardware store.
small holes on the tank base (Fig. 10).
QTY.
6
Fig. 8
Pole screw
(M5x12)
Fig. 9
Fill the hole
with sand
until it's full.