Manual Charging - Black and Decker BXVR500E Manual De Instrucciones

♦ Charge the battery at room temperature between 4 and
40ºC.

Manual charging

♦ Put the robot in the charging base and ensure that the
automatic charging poles are aligned correctly.
Danger! Électrocution
♦ The blue LED (D) will light blinking. When the LED stops
blinking and turns blue the robot is charged.
♦ Charge the robot for 4 hours before the first use.
Manual charging via the remote control
♦ When the appliance is in standby mode or in a cleaning
mode press the button to activate the recharge
mode.
Auto charging
♦ In a low battery condition the operation button (D) turns
blue and blink entering into recharge mode.
NOTE: If the battery is about to run out, the robot will
return to the charging base automatically to recharge.
NOTE: If the load base is inaccessible, the robot can not
be recharged, it will return to the initial situation and the
cleaning system will end. In this case, place the robot
manually in the charging base so that it can be recharged
correctly.
NOTE: The appliance may fail to return to the base either
because of complex surrounding obstacles or running-out-
of batteries.
(Original instructions)
OPERATE THE ROBOT MANUALLY
Turn on the vacuum cleaner
♦ Press the operation button (D) 2 seconds to awaken the
robot. The red indicator will light (Stanby mode).
Auto cleaning mode
♦ Press shortly the operation button (D) to start cleaning in
AUTO mode. The indicator will turn blue and it will start
cleaning automatically.
Auto Recharge mode
♦ When the appliance is in standby mode or in a cleaning
mode, double ckick the operation button (D) and then the
indicator turns blue and blinks at the same time, which
means it enters auto-recharging mode.
ENGLISH
7