Cleaning And Maintenance - Black and Decker M290 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH
Fig. A
5. Bowl (M600)
6. Stand (M600)
7. Beaters
8. Dough hooks
Assembly
Warning! Before assembly, make sure that the appliance is
switched off and unplugged.
Fitting and removing accessories (fig. A & B)
Use beaters for mixing, beating, whipping and creaming
N
liquids and mixtures.
Use dough hooks for mixing and kneading dough.
N
Fitting
Insert the stem of the accessory marked with the washer
N
(9) into the corresponding mounting hole (10) in the motor
unit as shown.
Push and turn the accessory until it locks into place.
N
Repeat for the other accessory.
N
Removing
Press the release button.
N
Remove the accessories from the motor unit.
N
M600 - Using the stand (fig. C - E)
Removing and replacing the bowl (fig. C)
Pull the lug (11) away and tilt the rest (12) into raised
N
position.
Take the bowl off the stand (6).
N
Installing and removing the appliance (fig. D)
Place the appliance into the rest (12) as shown.
N
While supporting the rest with one hand, firmly push the
N
front of the appliance down until it clicks in place. Then
push the rear of the appliance down until it fits tightly.
To remove the appliance, pull the lug (13) away and lift
N
the appliance from the rest. If there are any accessories
fitted, these must be removed first.
Fitting and removing accessories (fig. E)
Place the appliance into the rest (12) as shown.
N
Pull the lug (11) away and tilt the rest (12) into raised
N
position.
Follow the instructions as described above to fit or
N
remove accessories.
4
Use
Switching on and off
To switch on, move the speed control switch to one of the
N
positions 1 (lowest speed) to 5 (highest speed).
It is recommended to start at a low speed, then change to
a higher speed if necessary.
If required, press the turbo button (2) for extra power.
N
To switch off, move the switch to position 0.
N
Warning! Do not operate the appliance continuously for
N
more than 5 minutes. Do not operate the appliance
continuously in turbo mode for more than 1 minute.
After operating the appliance continuously for 5 minutes
(or 1 minute in turbo mode) let it cool down for at least
5 minutes before operating it again.
When working with liquids, use a low speed in order to
N
avoid splashing liquid onto the appliance.
Speed settings
Speed Application
1, 2
Folding
3
Blending
4
Mixing
5
Creaming and beating
The turbo button (2) can be used in all speed settings and
applications for any of the ingredients, except flour.

Cleaning and maintenance

Warning! Before cleaning and maintenance, switch the
appliance off and unplug it.
Wash the beaters and dough hooks in warm soapy water
N
and dry well.
Wipe the motor unit with a damp cloth. Do not use any
N
abrasive or solvent-based cleaner.
Warning! Do not immerse the appliance in water or any other
liquid.
M600 - Cleaning the stand
Wash the bowl in warm soapy water. Dry the bowl with a
N
soft cloth.
Wipe the stand with a damp cloth. Do not use any
N
abrasive or solvent-based cleaner.
Ingredients
Bulk and dry foods, e.g.
flour, butter, potatoes
Salad dressings
Cakes, cookies, quick breads
Butter, uncooked candy,
desserts

Publicidad

Tabla de contenido
loading

Tabla de contenido