Securing The Cable To The Ground - NOVARDEN NRL630 Manual De Instalación

Installing the perimeter cable

Securing the cable to the ground

Secure the perimeter cable around your lawn using the pegs and
your hammer (Figures 1 and 2). Use as many pegs as necessary to
ensure the cable stays in the ground. Leave a gap of at least 70 cm
between the pegs.
Figure 1
Once you have tested your installation with your robot mower, you
can bury the perimeter cable, if you wish.
To do so, using a trowel, dig a trench at least 2 cm deep in the place
where you plan to lay your cable. Place the cable in the trench and
cover back over with soil. It will not be visible to the eye but the robot
mower will be able to detect it.
NOTE: Corners must be rounded or smooth and over 90° (Figures 3 and 4). A
minimum length of 40 cm is required between two pegs.
<90°
Figure 3

13
<70 cm
Figure 2
>90°
>40 cm
Figure 4
EN