Black and Decker Workmate 500 Manual De Instrucciones página 4

588974-02,01,WM500 9/24/04
Fig. 6, 7 & 8: Installing the Vise Hand Cranks and Snap-in Knobs
1. Fig. 6: Remove and discard the plastic Vise Screw Packing Pieces (B).
2. Align the hole in the Vise Hand Crank (M) with the hole in the Vise Screw (area you
removed the vise screw packing pieces from), push the Vise Hand Crank onto the end
of the Vise Screw and realign the holes.
3. Using a hammer, drive the supplied Spring Pin (L) into the aligned holes.
4. Repeat this procedure for the installation of the other Vise Hand Crank.
5. Fig. 7: Complete the assembly by pushing the Snap-in Knobs (N) into the holes in
the Vise Hand Cranks.
6. Fig. 8: Tap the Vise Screw Protectors (R) into position as shown.
Fig. 9: Workmate Mode
After assembly the unit is fully open in the Workmate mode.
Operation:
Fig. 9 & 10: Storage Mode
1. Fig. 9: To close the unit from the workmate mode, push and hold the Transition Lever
(shown in the inset) to the right to unlock the unit.
2. Pull up on the upper cross member as shown.
3. Fig. 10: Release the Transition Lever and check that the unit is locked in the storage
position as shown.
Fig. 10 & 11: Hand Cart Mode
1. Fig. 10: With the unit in storage mode, use your foot to slide the Toe Plate Slider fully
to the right as shown in the inset.
2. Maintain Toe Plate Slider in this position while pushing forward and down on the Toe
Plate. This will release the locking mechanism and allow the Toe Plate to rotate
forward.
3. Fig. 11: The Toe Plate will lock in place when in the working position.
4. To stow the Toe Plate feature, reverse the operation.
5. With your foot slide the Toe Plate Slider to the right.
6. Continue the pressure on the slider and press down on the back of the Toe Plate with
your foot.
7. The Toe Plate should rotate up and back to the upright position.
8. When the Toe Plate can go no further, simply release the slider and the Toe Plate will
lock into place.
9. Check the Toe Plate is locked by tilting back and then forward on the top of the unit.
Fig. 12 & 9: To Convert Back Into Workmate Mode
Note: Ensure Toe Plate is in the upright (storage) position.
1. Push the Transition Lever (shown in the inset of Fig. 9) to the right to unlock the unit.
2. Fig.12 : Push down on the upper cross member as shown.
3. Fig. 9: Continue to push down until the unit locks (pins lock into outside frame) in the
Workmate position.
Features & Applications:
Fig. 13: Swivel Grips
The four supplied Swivel Grips (K) can be used in any of the holes in the Front and Rear
Vise Jaws. The Swivel Grips are used to extend the size of your Workmate's holding
capacity.
11:19 AM Page 4
3