Blanco ORION-S-F Información Tecnica Sobre Producto página 6

GB
Technical Product Information BLANCOORION-S-F ND / BLANCOORION-F ND
Parts list BLANCOORION-S-F ND
1 Lever
2 Coloured cap
3 Screw of the lever
4 Cover ring
5 Cartridge lock nut
6 Cartridge
7 Hose spray
8 Jet regulator
9 Seal spray hose
10 Spray hose
11 Fitting
12 Cartridge seat
13 O-ring
14 Inner body
15 Plastic ring
16 O-ring
17 Stabilising triangle
18 Mounting set
19 Coupling
20 O-ring
21 O-ring
22 Flow rate controller
23 Body
24 Plastic ring
25 Weight
26 T-Nipple with seals
27 Non return valve with seals
28 Seal flexi-hose
29 Flexi-hose
30 Flexi-hose
Technical Data
Applications
• Can be installed in front of a window
• Simply lift out and put aside
• Warm water tank low pressure
(open warm water heater)
Flow pressure
• Min.
• Max.
• Above 5 bar, a pressure reducer must be
installed.
The kitchen fitting is equipped with a flow rate
controller.
Temperature
• Max. (warm water inlet)
• Recommended (energy saving) 60° C
• Tap: warm-left / cold-right
4
1
Parts list BLANCOORION-F ND
Before installation and commissioning
Before the fitting is installed, the inlet pipes must
be thoroughly flushed so that no swarf, pieces of
hemp or other contaminants can enter the fitting.
Foreign bodies can enter the fitting through pipes
which have not been flushed, or the water system
in general, and damage the ceramic discs and
O-rings. The installation of a water filter is recom-
0,5 Bar mended in all cases.
5 Bar Before commissioning the fitting, unscrew the
jet regulator and flush well.
Installation
A tap borehole ø 35 mm is required. Flush all pipes
well in order to remove the dirt residues. Position
the kitchen fitting in the opening and ensure that
70° C there is a seal between the fitting and the surface
below. In the case of stainless steel sinks, mount
the stabilising triangle from underneath against the
sink to increase the stability. Fasten the fitting with
the mounting set (washer and nut).
1 Lever
2 Coloured cap
3 Screw of the lever
4 Cover ring
5 Cartridge lock nut
6 Cartridge
7 Cover cylinder
8 Jet regulator
9 Spout
10 Rubber ring
11 Plastic ring
12 Inner body
13 O-ring
14 O-ring
15 Coupling
16 Flow rate controller
17 Stabilising triangle
18 Mounting set
19 Seal flexi-hose
20 Flexi-hose
3