Medisana MC 818 Instrucciones De Manejo página 25

Use the buttons on control pad to operate the massage seat cover:
3.2
Operation • Switch on the device by pressing On/Off button
illuminates.
• When the "Upper Back" massage button
next to the button illuminates and the tapping massage heads
move from the "Park" position at the base of the backrest, up to the
shoulder area, massaging and relaxing the back with tapping whilst
doing so. Once the uppermost position has been reached, the direc-
tion the massaging heads is reversed. The heads then travel down
to the centre of the back. Once the heads reach this point, the direc-
tion is reversed again and then travel up the back again. If you press
button
massage heads remain stationary in their current position.
• If you press the "Lower Back" massage button
the button illuminates. The tapping massage heads
down the lower half of the back. The reversal of the direction takes
place when the respective end positions are reached. Pressing but-
ton
sage heads remain stationary in their current position.
• If you press the "Full Back" massage button
dure is similar to pressing buttons
entire back.
• You can choose the intensity of the tapping massage at any time
by pressing the button
dium intensity and level indicator LED "M" above the button lights
up. Press button
sage LED "H"). Press button again and the lowest intensity level
(low intensity massage, LED "L") is switched on.
• The heat function can be activated at any time with the tapping mas-
sage, during which the vibration massage can also be activated.
Press the heat button
• Press the SPOT button
current position and perform the tapping massage until you press
button
7
during the massage, this function is switched off and the
8
during the massage, switches off this function and the mas-
q
The heat is radiated through the massage heads
9
button again to de-activate the heat function; the LED goes out.
w
again.
7
and
q
. At start massage is performed with me-
and the level increases (highest intensity mas-
9
to activate the function; the LED lights up.
w
, the massage heads will stay at their
3 Operating
5
. The power LED
7
is pressed, the LED
8
, the LED next to
2
travel up and
6
the function proce-
8
, except that it is for the
2
. Press the
GB
2
17