Amazon Commercial B07SNGQQVW Guía De Bienvenida página 8

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ADDITIONAL SAFETY PRECAUTIONS
CAUTION
Know the pump applications, limitations, and potential hazards.
Make certain the electrical power source is adequate for the requirements of the pump.
ALWAYS disconnect the power to the pump and drain all water from the system before
servicing.
Secure the pump on a solid base to keep the pump vertical and above mud and sand during
operation to maximize pumping efficiency and prevent clogging and premature pump failure.
Secure the discharge hose before starting the pump. Pump torque may cause an unsecured
discharge hose to "whip", possibly causing personal injury and/or property damage.
Before using the pump, check hose for holes or excess wear, which could cause leaks, and be
sure hoses is not kinked or making sharp angles. A straight hose allows the pump to move the
greatest amount of water quickly.
Check that all hose connections are tight to minimize leaks.
Connect the pump DIRECTLY to a grounded, GFCI outlet.
Extension cords may not deliver sufficient voltage to the pump motor. Extension cords present
a life-threatening safety hazard if the insulation becomes damaged or the connection ends fall
into water.
Make certain the electrical circuit to the pump is protected by a 10-amp or larger fuse or
circuit breaker.
Periodically inspect pump and system components, to be sure pump inlets are free of mud,
sand and debris. DISCONNECT PUMP FROM THE POWER SUPPLY BEFORE INSPECTING.
Wear safety glasses at all times when working with pumps.
Follow all electrical and safety codes, particularly the National Electrical Code (NEC) and in
the workplace, the Occupational Safety and Health Act (OSHA).
This unit is designed only for use on 115 volts (single phase), 60 Hz, and is equipped with an
approved 3-conductor cord and 3-prong grounded plug. DO NOT REMOVE THE GROUND
PIN UNDER ANY CIRCUMSTANCES. The 3-prong plug must be directly inserted into a
properly installed and grounded 3-prong, grounding-type receptacle. Do not use pump with
a 2-prong wall outlet. Replace the 2-prong outlet with a properly grounded 3-prong
receptacle (a GFCI outlet) installed in accordance with the National Electrical Code and local
codes and ordinances. All wiring should be performed by a qualified electrician.
Protect the electrical cord from sharp objects, hot surfaces, oil, and chemicals. Avoid kinking
the cord. Do not use damaged or worn cords.
8

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Commercial b07srxpht1

Tabla de contenido