Activating Parking Function; Activating Maintenance Stop Function; Maintenance; Maintenance Cycle Control - Cramer 82P Manual Del Usuario

Activating Parking Function

WARNING!
Disconnecting the cable of the pruning shears/harness
without parking or activation the Maintenance Stop function
can cause the loss of data from the memory and void
the guarantee.
To park the pruning shears at the end of work or for storage, close
the cutting blade by holding down the On/Off button (14) on the user
interface (2) and squeezing the trigger (1). The cutting blade will close,
three acoustic signals will sound, and the LED indicator (12) will
immediately turn off. Once the cutting blade has reached the "closed"
position, release the trigger and the On/Off button.

Activating Maintenance Stop Function

To activate the Maintenance Stop function (primarily used for cleaning
and sharpening the cutting blade), hold down the On/Off button (14) on
the user interface (2) for 5 seconds, three acoustic signals (see Table 2)
indicate that it has stopped for maintenance.
Make a test run by squeezing the trigger to ensure that it has stopped.
To deactivate the Maintenance Stop function, press the On/Off button
of the LCD display for 1 second until it gives one acoustic signal.

Maintenance

Maintenance Cycle Control

The pruning shears are provided with a log of the pruning shears cutting
cycles, average consumption, hours of work, and battery charging,
which regulates times between services with greater reliability and
thus extends the useful life of the pruning shears. We recommend
service by authorized technical service center each 500,000 cutting
cycles. The pruning shear will inform you when it is time (see Table 3).
Table 3. Maintenance Cycle Control Program Service Warnings
CUTTING CYCLES
After 490,000 Pruning shears will stop cyclically
(approximately every 2,000 cutting cycles)
and will make 10 acoustic signals.
After 500,000 Pruning shears will stop cyclically
(approximately every 1,000 cutting cycles)
and will make 10 acoustic signals.
After 510,000 Pruning shears guarantee is void.
The shears will give no further acoustic
signals and will no longer stop due to a
maintenance warning.
After each stop with a repair warning, start-up must be performed by
holding down the On/Off button on the LCD display and squeezing the
trigger of the pruning shears.
EN GB
ACTION
15
cramer.eu