Troubleshooting - Cramer 82P Manual Del Usuario

Troubleshooting

EN
PROBLEM
Control unit does not work.
Pruning shears have stopped
working.
* If the fault is not solved, you must go to your distributor and/or nearest Authorized Technical Service.
18
cramer.eu
PROBABLE CAUSE
Control unit is not properly connected to the pruning
shears.
Overloading (cutting stop).
Maintenance warning (stop with 10 short acoustic
signals).
Pruning shears are not properly connected to the
control unit.
Pruning shears blades not in closed position.
WARNING!
Keep fingers out from between blades.
Battery charge is very low.
POSSIBLE SOLUTION *
Check the connection between the control
unit and the pruning shears.
The pruning shears have stopped due
to overloading, the pruning shears stop
automatically.
Start up with the usual process.
The pruning shears must pass the technical
service control for maintenance (see
Maintenance Cycle Control).
Make sure the pruning shears are properly
connected to the control unit.
Disconnect the pruning shears from the
battery and manually close the cutting blade
by pressing with the palm of your hand.
Start with the usual process.
Make sure the batteries are charged (see
Batteries and Battery Charger).