Tabla de contenido
Publicidad
W
hIrlPool systems oPeratIon
VExxP1
1) Place the omnipolar switch in the "I" position.
2) The LED of the O/I key
red to indicate that the unit is powered.
3) Fill the tub to the desired level.
4) By now pressing the key O/I
whirlpool, the LED will come on steady green
and at the same time the blower will start.
5) To interrupt, press the key 0/I
6) At the conclusion of the whirlpool, place the
omnipolar switch back in position "0".
Speed change
With the blower on, hold the ' airpool ON-OFF'
key down for at least 0.5 to enter variation mode.
Continue holding the key to increase or decrease
power continuously. Stop at the desired position.
Release the key before the blower reaches maxi-
mum or minimum power to set blower operation
at the desired power. If you want to change the
power later, proceed as described above.
Note: For the Air System VE08P1, the pipe system
is sanitized. This consists of automatically drying
the pipes for 30 seconds after 10 minutes from
blower shutdown. You can stop the drying cycle
at any time.
System VExxP1
System VExxP1 SOFT TUB
TT0283385_02_SOFT_CMYK.indd 13
VExxP1 (SOFT TUB)
1) Place the omnipolar switch in the "I" position.
2) The led of the key 0/I
comes on steady
3) Fill the tub to the desired level.
4) By pressing the key O/I
the LED will come on steady blue and at the
to start the
same time the blower will start.
5) To interrupt, press the key 0/I
6) At the conclusion of the whirlpool, place the
.
omnipolar switch back in position "0".
Duration of whirlpool
The intensity of the whirlpool depends on your
personal preferences. At less than 37°C the func-
tion is stimulating and may last as long as 20 min-
utes. For the relaxing function, the recommended
temperature is 38/40° but bathing should not last
more than 10 minutes.
Staying in the whirlpool too long may cause a drop
in blood pressure or excessive muscle relaxation.
In any case, the maximum duration of the whirl-
pool cycle is set at 45 minutes. When this time has
elapsed, the system shuts down automatically.
Phase
Standby
Presence of H
O
2
in safety tank
Whirlpool operation
Phase
Standby
Presence of H
O
2
in safety tank
Whirlpool operation
remains off.
to start the whirlpool,
.
LED
Steady red
Flashing
green and red
Steady green
LED
-
Flashing blue
Steady blue
5-07-2010 16:34:01
13
Publicidad
Tabla de contenido
