4. Crimp or tie together all the wires using a cable tie to
keep tidy.
5. Insert plug into the header of Junction Box. Push in
uniformly until it is fully inserted.
Side screws
Figure 10: Accessories Plug Installation
6. Screw the side screws to ensure that the plug is securely
fastened.
7. To remove, unscrew the side screws and use a small flat
head screwdriver (such as test pen screwdriver) to
carefully pry the plug out from the header.
Connecting to Vehicular Cradle
1. Avoiding visual or physical obstruction, route the cables
down inside the door moulding and beneath the carpets
and seat(s).
2. Secure the Cradle to Junction Box Cable (PMKN4169) or
Cradle to Junction Box Cable with USB Data Cable
(PMKN4170) from the Vehicular Cradle by screwing the
screws onto the connector of the MTP6000 Car Kit
Junction Box as shown in Figure 11.
Small screw
for each pin
15