Important Safety Information; General Information; General Safety Information - Ford Connected Wall box Manual De Instalación

2

Important Safety Information

EN
2.1

General information

The Ford Connected Wall Box has been developed, pro-
duced, tested and documented according to the relevant
safety regulations and environmental requirements that ap-
ply to your geographical area.
You must only use the wall box in a technically faultless
condition. Any malfunctions that adversely affect the safety
of persons or of the device must be immediately rectified by
a qualified electrician in accordance with applicable regula-
tions and warranty conditions. It is strictly prohibited to
modify, change or manipulate the device.
NOTE
Signalling in your vehicle may differ from that described
in this guide. Always read and observe the vehicle manu-
facturer's user manual.
2
2.2

General safety information

WARNING
- You must comply with the locally applicable require-
ments regarding electrical installations, fire protection,
safety regulations, and escape routes at the intended in-
stallation location.
- Hazardous voltages are present within the casing.
- The Ford Connected Wall Box does not have its own
mains ON/OFF switch. The protective devices installed in
the power supply system are therefore also used to dis-
connect the power supply.
- Inspect the wall box for visual damage before installa-
tion and use. Do not use the wall box if it appears to be
damaged.
- Installation, electrical connection and initial operation
of the wall box must be carried out by a qualified electri-
cian.
- The screw-mounted unit cover may only be removed by
qualified electricians.
- Do not remove markings, warning symbols or the type-
label from the wall box.
- The charging cable may only be replaced by qualified
electricians and in accordance with the installation
manual.
- You are strictly prohibited from connecting other equip-
ment/devices to the wall box than those for which the
wall box was designed and intended.
WARNING
- When not in use, store the charging cable in the desig-
nated holder and lock the charging coupling in the re-
mote dock. Loosely wind the charging cable around the
remote dock making sure the cable does not touch the
floor.
- You must make sure that the charging cable and coup-
ling cannot be driven over, trapped and are protected
from all other hazards.
SKLJ98-10C823-AA
WARNING
- Immediately notify Customer Service if the wall box,
charging cable or the charging coupling are damaged. Do
not continue to use the wall box.
- Prevent the charging cable and coupling from coming
into contact with external heat sources, water, dirt and
chemicals.
- Switch off power at the circuit breaker before installing
or cleaning.
- Do not attach extension cables or adapters to the char-
ging cable.
- Never clean the wall box with a high-pressure cleaner or
similar.
- Switch off the power supply before cleaning the char-
ging sockets.
- The charging cable must not be subjected to any strain
during use.
- You must make sure that no one has access to the wall
box without reading this user manual first.
- Make sure that the wall box temperature is within its
storage temperature limits when moving, transporting, or
storing it.
- You are strictly prohibited from pulling the wall box by
its cable.
- The Ford Connected Wall Box must be connected dir-
ectly to your home's mains connection; no plugs and
sockets must be used.
- You may only operate the wall box after professional in-
stallation.
WARNING
When transporting the Ford Connected Wall Box, handle
with care. Do not subject it to strong force or impact, also
do not pull, twist, tangle, drag, or step on the Ford Con-
nected Wall Box, to prevent damaging it or any of its
components.
NOTE
In addition to the safety instructions in this document,
also observe further safety instructions in any other en-
closed documents.
Ford Connected Wall Box Installation Manual