Wi-Fi; In The Box; Power Supply Interface Connections; The 1-Phase Variant - Ford Connected Wall box Manual De Instalación

3.1.2

Wi-Fi

You can use Wi-Fi communication to connect the wall box
to the charging backend. This enables you to configure the
charger remotely through the FordPass™ App.
3.2

In the box

Scope of delivery for the Ford Connected Wall Box. See Fig.
19 on the inside of the back cover.
Main Unit
A
Design Cover
B
Charging cable with coupler
C
Blind plugs
D
Wall mount bracket
E
Dock rear holder, dock front cover & dock insert
F
Screw M5 x 12 mm
G
Screw M4 x 16 mm
H
See also chapter 5.3.1, "Required tools" on page 7.
Power supply interface
4
connections
Check whether the power supply is 1- phase or 3-phase.
NOTE
To release the power supply connections, use an insu-
lated slot-head screwdriver by inserting it into the
opening immediately above push-in terminal.
Fig. 1
4.1

The 1-phase variant

– The 3 terminals on the right, marked PE, N/OUT, and L1/
OUT, must be connected to the charging cable.
– The 3 terminals on the left, marked L1/IN, N/IN, and PE,
must be connected to the AC mains connection.
NOTE
For appropriate installation of the charging cable, see
Installing the charging cable.
NOTE
For appropriate installation of the grid cable for the
wall box, see Connecting the grid cable.
Ford Connected Wall Box Installation Manual
4.2

The 3-phase variant

– The 5 terminals on the right, marked PE, N/OUT, L1/
OUT, L2/OUT, and L3/OUT must be connected to the
charging cable.
– The 5 terminals on the left, marked L3/IN, L2/IN, L3/IN,
N/IN, and PE, must be con-nected to the AC mains con-
nection.
NOTE
To release the power supply connections, use an insu-
lated slot-head screwdriver by inserting it into the
opening immediately above push-in terminal.
NOTE
For appropriate installation of the charging cable, see
Installing the charging cable.
NOTE
For appropriate installation of the grid cable for the
wall box, see Connecting the grid cable.
SKLJ98-10C823-AA
EN
5