Adler europe AD 7925 Manual De Uso página 7

once. The device LED panel shows the target temperature for 5 seconds and then displays the room temperature.
4. Adjust fan speed
Press the button "B" to select a desired fan speed shows by sequence:
Low speed "F" -> High speed G
5. Power
When you press the "A" button again, the device will sound "di" and stop working.
6. Press this button "I" to enter the sleep mode of device.
7. Press this button "N" to set a timed shutdown.
Press this button "O" to set air swing oscillation in left-right directions.
Each mode working principle:
AUTO "J" mode:
Once the "J", operation is selected, the indoor temperature sensor operates automatically and it selects one of below operation modes:
- When the room temperature ≥24 ℃ the unit will automatically select cool mode "K" mode.
or
- When the room temperature ＜24 ℃, the unit will automatically select high fan speed mode "M..".
Dry "L" mode:
1. The up centrifugal fan will run at low speed, and the speed can't be adjusted.
2. The compressor will stop after running 8 minutes, then run again after 6 minutes.
3. The device adopts constant temperature dehumidifying mode, and the adjustment of temperature is no effective.
COOL "K" mode:
1. When the room temperature is higher than set temperature on control panel, the compressor starts to run.
2. When the room temperature is lower than set temperature on control panel, the compressor stop and upper fan operates at original set
speed.
Fan "M" mode.
1. The up centrifugal fan runs at set speed, and the compressor does not run.
2. The adjustment of temperature is no effective.
Timer operation "N":
1. Press "N" button to set Automatic Off time while the unit is running.
2. Press "N" button to set Automatic On time while the unit is ready.
3. The time can be adjusted within a range of 1 hour to 24 hours by pressing the button "D"（+）or "E"（-.
Sleep mode "I" operation:
1. The sleep mode operations when the unit is under cooling "K" mode.2. Press the button "I" in cool mode "K" , then the unit will work
7