Assembly - Weston 82-0250-W Manual Del Usuario

ASSEMBLY

w WARNING
ENTANGLEMENT HAZARD: Disconnect power before
cleaning, disassembling or assembling.
1. Insert the Auger into the Head.
FIGURE C
2. The place the screen over the auger and
line up notch with the tab located on the
bottom of the Head. Hold screen in place.
3. Slide the Front Ring Nut over the Screen
assembly and turn clockwise to firmly
tighten (make sure the tabs on the Screen
remain aligned with the notches on the
Head). DO NOT over-tighten the Front Ring
Nut to avoid damaging the Motor during operation
(FIGURE C).
4. Insert assembled Screen and Head into the
large opening of the Chute. Make sure that the
FIGURE D
end of the Screen exits the smaller opposite
opening. The assembled Screen and Head will
click into place (FIGURE D).
5. Align the notches on the Grinder Head with
the tabs on the Main Body.
6. Press the Grinder Head against the Motor
and rotate it counterclockwise until it locks into
place (FIGURE E).
7. Rotate the Chute until the desire angle is
reached.
FIGURE E
9