Amano American Sanders FloorCrafter Manual Del Operador página 10

EN
u the tch o
6 ot te the e e e e e o
CAUTION: Damage to the sanding drum will occur if the machine is operated without a sanding belt.
t e e e t
8. Rotate the release lever backward to tighten the abrasive belt.
A N o ot o ce the e e e e e
9. Depending on the model, the control switch is found on either the operating handle or on the motor. Verify that the control switch is set to
ee the k o the
10. Connect the electrical cord. On certain models, the connection must be twisted clockwise to lock.
11 o tu o o e t
A u t e t oce u e o
belt adjustment.
12 o e the cce oo
mainframe to secure.
Figure 11
Machine Setup
to e e e the cce oo to
ee u e 11
Figure 9
the e o e the te o o e
o o c
tch
- te t o e t o the co t o
e 16 to co ect the e t t ck
ce the e o the tch o e the kee e o the cce
e t to the ch
co t ct hee
e the t ck ech
tch h e o e the e t t ck
he e o e o the
10
e ee u e 12
Figure 10
ee u e 12
c u e the e e t to
o o the oce u e out e
e o the cce oo th t out e the
oo u h the tch
Figure 12
-t ck
the e
t t the