Contents Of Under Counter System; Recommended Tools For Installation; Using Quick-Connect Fittings; System Diagram - Watts pure H2O-DWCB100 Manual De Instalación, Operación Y Mantenimiento

Contents of Under
Counter System
Please make sure all of the items listed below are contained in the
box. If any of the items are missing please contact retail customer
service at (888) 321-0500 prior to installing.
• Filtration System
• High Capacity Carbon Block filter (attached to filter head)
• Brass Insert, Delrin Sleeve, Brass Nut, Blue Tube, QC Union,
Quick Stem Adapter, Screws
Recommended Tools
For Installation
• Small knife or tube cutter
• Variable speed drill
• 1/8" (3mm), 1/4" (6.4 mm) and 7/16" (11.0mm) drill bits
• Adjustable wrench
• Phillips screwdriver

Using Quick-Connect Fittings

Cutting
Cut the tube square. It is
essential that the outside
diameter be free of score
marks, and that burrs and
sharp edges be removed
before inserting into fitting.
Connecting
Make certain to push
the tubing completely
into the connector until
it comes into contact
with the internal tubing
stop. The collet (gripper) has stainless steel teeth which hold
the tube firmly in position while the O-ring provides a permanent
leak proof seal.
Pull on the tube to check that it is secure. The system must be
tested prior to leaving the site and/or before use.
Disconnecting
To disconnect, ensure the
system is depressurized
before removing the tube.
Push in collet squarely
against the face of the
fitting. With the collet held in this position, the tube can be
removed. The fitting can then be reused.

System Diagram

Parts List
Item
A Brass Insert (not shown)
B Delrin Sleeve (not shown)
C Brass Nut
D Blue Tube
E QC Union
F Quick Stem Adapter
G High Capacity Quick Turn Carbon Block Filter (H2O-F45)
Page 3
F
E
HOT COLD
C D
B
G
A
Description
D