Du Pont WFPF38001C Serie Instrucciones De Instalación página 5

STEP 3
Assemble the System
1
Dry assemble the complete system (according to the configuration chosen), including all fittings and valves.
OPTIONAL: If using a mounting bracket (not included), position it on the Filter System Head in alignment with the inlet and outlet ports.
2
Measure the overall length (see diagram) of the configured system.
3
Reduce this measurement enough to allow for the amount of engagement (X) to determine how much pipe to remove from the line.
STEP 4
Mark Measurements and Cut the Plumbing Pipe
CAUTION
1
Mark the section of the plumbing pipe that will need to be removed (X) to allow for the configured system (as determined in Step 3).
NOTE: Measure twice, cut once!
2
Using a pipe cutter or hacksaw, cut the marked section from the plumbing pipe.
NOTE: Use a pan or bucket to catch any remaining water in the pipes.
3
Remove any burrs or debris from the cut edges with a file.
WFPF3800
Please wear safety glasses to protect eyes when cutting.
5
3
1
2
X
3
4
V4.2L