easyGO nino isoFIX Manual Del Usuario página 15

Tighten the strap.
4.Seat installation for group III (children
weighing 22-36 kg) with 3-point car seat belt.
Adjust the headrest height to the child's height
(see: "Headrest height adjustment") (fig. 27).
For further installation, see instructions for group
II (point 3).
5.Seat installation for groups II and III
(children weighing 15-25 kg and 22-36 kg)
with ISOFIX connectors and Top Tether.
Fasten the seat with ISOFIX connectors and Top
Tether (see point 1), and follow the instructions
specified in point 3 for group II and in point 4 for
group III.
USING INSTALLED SEAT FOR GROUP I
(children weighing 9-18 kg)
1.Adjusting the length of 3-point car seat
harness.
To loosen the harness, press the strap length
adjuster button and pull shoulder straps
downwards (fig. 28). Warning! Do not pull by the
strap pads.
2.Headrest adjustment.
To adjust the headrest, pull the lever in the rear
part of the headrest and set the desired position
(fig. 29). For group I, the headrest adjustment
mechanism is integrated with the shoulder strap
adjustment mechanism and has 5 points. When
the safety harness is removed and the seat is
used for groups II and III, the headrest gains 4
additional adjustment points. Make sure that the
headrest is adjusted appropriately to your child's
head (fig. 30).
3.Seat recline adjustment.
The seat has 5 points of recline adjustment.
To adjust the recline point, pull the lever under
the front part of the base and recline the seat.
You should hear a characteristic "click" when
you properly lock the seat in the given position
(fig. 31).
4.Securing the child with 3-point harness.
Loosen the straps according to point 1 above.
Unfasten the middle buckle and disconnect the
shoulder straps (fig. 32). Move the shoulder
straps to the sides and place your child in the
seat (fig. 33). Reconnect the shoulder straps and
slide them into the middle buckle (fig. 34). Adjust
headrest and shoulder straps to appropriate
height (fig. 35). Tighten the straps by pulling on
the length adjuster band (fig. 36). Make sure that
the harness is tight, but not too tight to prevent
the child's discomfort.
REMOVING 3-POINT SEAT HARNESS AND
REMOVING THE UPHOLSTERY
Recline the seat to maximum (see: "Seat recline
adjustment"). Pull out the bottom backrest lock
and push the backrest forward (fig. 37). Loosen
the straps by pressing the strap length adjuster
button and remove the shoulder straps from the
metal buckle in the bottom part of the backrest
(fig. 38). Pull out the shoulder strap axle (fig. 39)
and pull out the shoulder straps from the slots
in the backrest (fig. 40). Lift the upholstery and
slide the strap locking buckles though the slots
in the seat (fig. 41). Remove the crotch strap
with the middle buckle by leading the locking
buckle through the slot in the seat (fig. 42).
After removing the 3-point harness, you can
remove the upholstery (fig. 43).
To put the upholstery and harness back in place,
perform the actions presented above in reverse
order.
15