Horizon Global 24975 Instrucciones De Instalación página 6

1f. Remove fascia - using a trim panel tool, remove the fascia starting at the
outer edges near wheel wells while gently pulling rearward on the
fascia. Disconnect the wiring harness from fascia and set fascia aside.
3. Remove bumper beam – using a 13mm socket, remove the remaining (5) bolts holding the bumper beam to the end panel and set aside. Save (2) hex nuts to
reattach the blind spot sensors, (1) per side. Return remaining fasteners to vehicle owner.
©2018 Horizon Global™ Corp - Printed in Mexico
2. Remove blind spot sensors – using a 13mm socket, remove the (2) outer
bolts holding the bumper beam and sensor on driver's side. Using a
10mm open end wrench, remove the hex nut behind the sensor wiring
harness, both sides. Using a 10mm socket, remove the (2) hex nuts
holding sensor on the passenger's side.
Sheet 6 of 24 24975NP 05-22-18 Rev. A