Horizon Global 76244 Instrucciones De Instalación página 4

1. Remove factory tow loop if present- Remove (2) bolts using 14mm socket
and factory tow loop from passenger side frame rail. Return bolts and tow loop
to vehicle owner.
3. Install fasteners - Insert carriage bolts and blocks into existing holes in the
side of the frame rails. Adjust carriage bolts to be flush with the inside of frame
rails. Note: On the driver side, the carriage bolts are installed by reaching
between the bumper fascia and over the top of the carbon canister.
©2018 Horizon Global Americas Inc. - Printed in Mexico
2. Lower Exhaust- Lower exhaust by removing the (2) rubber hangers by the
muffler and (1) rubber hanger just forward of the muffler.
support the exhaust when removing the rubber hangers.
4. Install hitch - Raise the hitch into position and push the carriage bolts
through the holes in the hitch. Loosely install the ½" conical washers (teeth side
toward hitch) and hex nuts onto carriage bolts. Tip: for ease of installation, raise
the driver side of hitch first, guiding the flange on side bracket around the carbon
canister. Then raise the passenger side into position.
Sheet 4 of 15 76244NP
Note: Be sure to
7-15-18 Rev. A