Thetford N3000 Serie Manual Del Usuario página 6

EN
3 Switch on refrigerator
After 10 seconds the settings will dim. The green
light indicates the refrigerator is still in function.
To check the settings push the on/off switch.
The last selected settings will light up.
To secure optimal performance, level your
vehicle before operating the refrigerator.
For optimal performance, switch on the
refrigerator 8 hours before placing food.
We advise to clean the inside of the
refrigerator properly, before using your
refrigerator.
4 Selecting source
Sources
Auto
The automatic function is not present on all
refrigerator types.
230V
12V
Gas
To switch on the
refrigerator, push the on/off
switch and hold it for
1 second, as illustrated.
A light in the on/off switch
will turn green.
After switching on the
refrigerator, push the
confirmation button and
hold it for 2 seconds. The
symbols for the sources
light up and start to blink.
Choose the desired source
by pushing the arrow
buttons.
Confirm your choice with
the confirmation button.
The refrigerator automatically
selects the best source available
(in order: mains, battery, gas)
The refrigerator is powered from
the mains.
The refrigerator is powered from
the battery of your vehicle.
The refrigerator is powered from
the gas connection of a gas
bottle.
If you set the refrigerator on the automatic source
selection, the control panel will show two source
symbols; the A and the best source available.
Always use the gas connection or mains voltage
to start up and cool. Operating on 12V is only
effective while the engine of the vehicle is running.
The performance of the refrigerator, when
operating on 12V, is dependent on the thickness
and length of the wiring and the overall installation
of the vehicle.
Sufficient power and voltage must be available
in order for 12 V units (e.g. refrigerator, ATC, etc)
to operate reliably while travelling. In rare cases,
due to the towing vehicle's battery management
system, in some car models there may not be
enough power and voltage available for external
units. If this is the case, please contact the car
manufacturer directly for further information.
To secure optimal performance, deactivate
the start/stop system on your vehicle if
present.
If the refrigerator is powered by a gas connection,
make sure that the control panel is powered from
the battery or AA batteries (in the case of a stand-
alone model).
When selecting gas, the flame should be ignited
within 30 seconds. If the system fails, restart the
refrigerator and select the gas
source again.
For safety reasons it is not possible to ignite the
flame within 15 minutes after driving.
From about 1000 m above sea level problems of a
physical nature can occur when lighting the gas.
This does not mean that the refrigerator is not
working properly.
Stand-alone model
The refrigerator is only functional, when the
control panel is powered.
A stand-alone model (installed by your dealer) is
operational using AA batteries in the event of no
mains or battery.
6
Therefore open the small
cover underneath the
control panel, as illustrated.
Insert 6 new 1.5V AA/LR6
batteries, according the
illustration in the cover.