Introduction; Device Description (Fig. 1) - Scheppach WSE5000-Multi Traducción De Manual De Instrucciones Original

1.

Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling,
• Non-compliance with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts
• Application other than specified
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
13 / VDE0113 not being observed
Please consider:
Read through the complete text in the operating manu-
al before installing and commissioning the device.
The operating manual is intended to help the user to
become familiar with the machine and take advantage
of its application possibilities in accordance with the
recommendations.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex-
tending the service life of the device. In addition to the
safety instructions in this operating manual, you must
also observe the regulations applicable to the opera-
tion of the device in your country.
Keep the operating manual package with the machine
at all times and store it in a plastic cover to protect it
from dirt and moisture. They must be read and careful-
ly observed by all operating personnel before starting
the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.

2. Device description (Fig. 1)

1. Gas connection
2. On/off switch
3. Carrying handle
4. Potentiometer for setting the welding current
5. Welding current display
6. Potentiometer for wire feed and for setting the
electrical current
7. Wire feed indicator
8. Hose assembly connection (MIG/MAG)
9. Quick coupling connection positive
10. Quick coupling connection negative
11. Quick coupling for polarisation change
12. Combination wire brush with slag hammer
13. Welding mask
14. Rod electrodes (5x)
15. Contact tip (4x)
16. Welding wire reel (2x)
17. Indicator lamp for operation
18. Indicator lamp for overheating
19. MIG welding process
20. MMA welding process
21. LIFT TIG welding process
22. Selection button for welding process
23. Welding wire diameter 1.0 /AI
24. Welding wire diameter 0.6 - 0.9
25. Welding wire diameter 1.0
26. Selection button for welding wire diameter
27. Hose assembly
28. Burner button
29. Burner
30. Burner nozzle
31. Electrode holder
32. Earth clamp
www.scheppach.com GB | 29