Using Your Ceiling Fan - Fanaway ORBIT LD-36 CTC Manual Del Usuario

Fanaway Orbit Installation Instructions
INSTALLATION OF THE REMOTE CONTROL HOLDER (Fig. 8)
1. Locate a suitable wall to fix the remote control holder with the 2 screws. (Fig.8a).
Slide the remote into the holder. (Fig. 8b)
2.
NOTE: The remote and receiver will need to be paired after the installation of the ceiling fan.
NOTE: When two or more ceiling fans are installed in one location, please refer to the
instruction on the next page.
PAIRING REMOTE & RECEIVER – WHEN 1 DC CEILING FAN IS INSTALLED IN ONE LOCATION
NOTE: Ensure that you have installed a single pole disconnection switch in the fixed wiring for the fan.
NOTE: Ensure power to the receiver is ON prior to pairing the remote with the receiver.
•
Turn OFF the mains supply to the fan by on/off wall switch.
•
Install the batteries into the remote. Please make sure the polarity of the battery is correct.
•
Turn ON the power to the receiver.
•
Press and hold the
ON to the receiver of the ceiling fan.
•
There will be a notification 'beep' sound from the receiver to indicate that the paring process is
successful.
•
Turn ON the fan and change the speed of the ceiling fan via the remote to check the operation and
successful paring.
11 | P a g e
Fig. 8a

USING YOUR CEILING FAN

button on the remote for 3-5 seconds within 30 seconds of switching the power
Fig. 8b