Installing The Monting Plate - Hinkley COLLIER 54 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLING THE MONTING PLATE

Fig. 1
Light Wires
Fig. 2
Upper
motor housing
Bottom
motor housing
Screws
Mounting Hub
5
(bottom of motor)
Adapter
plate
Screws
NOTE: Be sure the power is off before installing.
Re-install the bottom motor housing. (Fig. 1)
Remove one of the three screws on the mounting hub
1
located on the fan motor. Loosen the other 2 screws. (Do
not remove) (Fig. 2)
2
Pass the light wires through the center hole of the adapter
plate.
3
Place the key holes on the adapter plate over the 2 screws
previously loosened, turn the adapter plate until it locks in
place at the narrow section of the key holes. Secure by
tightening the 2 screws previously loosened and the one
previously removed.
©2020 Hinkley Lighting, Inc. | hinkley.com |
11

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

903254fpw-lid54 collier

Tabla de contenido