Hinkley 980017 Serie Instrucciones

Control is only compatible with the following Hinkley fans
980017FWH-002:Bimini 60" (900260)
980017FWH-013L:Grand Marquis (GMRP-BN)
980017FWH-013:Marquis 52" (901352)
980017FWH-015:Windward 52" (901552)
980017FWH-016:Oasis 52" and 60" (901652 and 901660)
980017FWH-0097:Indy 72" (900972)
GENERAL INFORMATION
This wall control is designed to separately control your ceiling fan speed and light brightness.
The fan button will control the fan speed. (Hi, Medium, Low)
The light buttons will control the lights, brightness dimmer and off.
The red indicator on the transmitter will light when the button is pressed.
INSTALLATION AND OPERATING INSTRUCTIONS
NOTE: This wall control unit is equipped with 16 code combinations to prevent possible interference from or to other remote units. The
frequency switches on your receiver and transmitter have been preset at the factory. Please recheck to make sure the switches on
transmitter and receiver are set to the same position, any combination of settings will operate the fan as long as the transmitter and
receiver are set to the same position.
1. SETTING THE CODE
This unit has 16 different code combinations. To set the code, perform these steps:
A. Setting the code on the transmitter:
a. Slide the code switches to your choice of up or down position. (Factory setting is all up). Do not use this Position. Use a small screwdriver or a
ballpoint pen to slide firmly up or down (Figure A).
B. Setting the code on the receiver:
a. Slide the code switches to the same positions as set on your transmitter (Figure B).
ON
Code switches
Fig. A Transmitter
2. INSTALLING RECEIVER IN THE CEILING FAN
A. Safety precautions:
WARNING: HIGH VOLTAGE! Household electrical power can cause serious injury or death. Disconnect the source of electrical power
to the ceiling fan by removing the fuse or switching off the circuit breaker.
B. Installing receiver in fan.:
a. Remove the ceiling fan canopy from the mounting bracket.
b. Disconnect the existing wiring between the ceiling fan and supply at the electrical junction box.
c. Lay the black antenna wire on top of the receiver, and put the receiver in the mounting bracket. (Fig. C)
d. Make the connections as follows, using the wire nuts supplied: (Fig. D)
CONNECT
Green fan wire...........................................Bare supply wire
Black receiver wire (AC IN L)..................Black supply wire
White receiver wire(AC IN N)..................White supply wire
White receiver wire (TO MOTOR N).......White fan wire
Black receiver wire (TO MOTOR L)........Black fan wire
Blue receiver wire(FOR LIGHT)..............Blue light wire
RECEIVER
Fig. C
3 SPEED FAN & LIGHT WALL CONTROL WITH SMART CONTROL
980017FWH-0095:Indy 56" (900956)
980017FWH-020:Tier 54" (902054)
980017FWH-017: Propel 52" (901752)
980017FWH-018: Cabana 36" (901836)
980017FWH-022: Vera Cruz 52" (902252)
980017FWH-023: Verge 52" (902352)
980017FWH-028: Ventus 44" (902844)
Fig. B
TO
Fig. D
RECEIVER INSTALLATION INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
NOTE: When installing the remote
control, be sure your fan control or
pull chain switch are in the "HIGH
SPEED" position and the light
control or switch is set to "ON".
Code switches
Receiver
AC SUPPLY
WHITE BLACK
RECEIVER
BLUE BLUE
BLACK BLACK
WHITE WHITE
BARE GREEN
Model: 980017
ON