Webasto SmarTemp Control 3.0 Manual De Instrucciones página 10

SmarTemp Control 3.0 Installation - Operating Instructions
Refer to the table below for an explanation of the various icons and their functionality
ICON
Function
Heater currently being controlled by the application.
Turns the heater ON or OFF.
Up to four timer events can be set, edited, and
activated using the timer function.
Temperature selection (air heaters only).
Opens the diagnostic screen. This allows passive
observation of outputs, activation of individual
components is not possible within the mobile
application. For full-featured access, PC Diagnostics
must be used.
This option does allow for clearing of fault codes,
printing a diagnostic report, and sending a diagnostic
report via e-mail or text message.
Status indicator:
Standby mode displays an image of the heater currently
selected.
Heat mode is indicated by a red icon. Remaining run
time is shows when timed operation is selected;
continuous duration is shown.
Ventilation mode is indicated by a blue icon. Remaining
run time is shows when timed operation is selected;
continuous duration is shown.
Battery voltage display.
NOTE: The voltage displayed is voltage present at the
SmarTemp connector.
Ambient temperature measured at the SmarTemp (air
heaters only).
10