Safety Instructions For Charger & Battery - Lumax LX-1182 Manual De Instrucciones

Caution:
To avoid any damage to the Air Release Valve and the
Battery Pack - when placing on a workbench or on the floor do
not let your RoboLuber sit it on its side.

Correct
SAFETY INSTRUCTIONS FOR CHARGER AND BATTERY PACKS

Charge only Lumax 20 Volt Battery Packs in Lumax Chargers.
WARNING!
Other types of Batteries may Explode causing Personal Injury and Damage
This manual contains important Safety and Operating Instructions for Lumax Model LX-2183 Battery
Charger.
• Before using a Battery Charger, read all instructions and cautionary markings on Battery Charger,
Battery Pack, and product using Battery. Caution: Never attempt to connect two Chargers together.
• CAUTION:
To reduce the risk of injury, Lumax Model LX-2183 Charger should only be used to
charge Lumax Battery Pack Model LX-2182. Do not charge Lumax Model LX-2182 Battery Pack with
any other Charger.
• WARNING:
If the Battery Pack is cracked or damaged, do not insert into Charger. Risk and
Danger of Electrical Shock or Electrocution.
• To reduce the risk of Personal Injury and Damage, never immerse your RoboLuber, Battery Pack
or Charger in Liquid or allow Liquid to flow inside them.
• Do not Expose Charger to Water, Rain, Snow, or Frost.
• Use of an attachment not recommended or sold by Lumax may result in a risk of Fire, Electric
Shock, or Injury to persons.
• Do not abuse Cord. Never carry Charger by Cord or yank it to disconnect from receptacle. Pull by
plug rather than cord when disconnecting Charger. Have "damaged" or "worn" Power Cord and
strain reliever replaced immediately. Do not attempt to repair Power Cord.
• Make sure Cord is located so that it will not be stepped on, tripped over, or otherwise subjected
to damage or stress.

Incorrect
11