Activating/Deactivating Music On Hold; Protecting Against Unauthorised Access; Resetting The Base To The Default Settings - Gigaset A510 Manual Del Usuario

Gigaset A510-A510A / USA en / A31008-M2202-R301-1-3S19 / registr_sett.fm / 25.08.2011
¤ Settings ¤ Audio Settings
§Menu§
¤ Ringtones (Base) ¤ Ringer Volume /
Ringer Melody / Time Control
For more information on adjusting the set-
tings, see page 45.
Activating/deactivating
music on hold
¤ Settings ¤ Telephony
§Menu§
¤ Music on Hold
§OK§
Press to activate or deactivate music on
hold (³ = on).
Protecting against
unauthorised access
Protect the system settings of the base sta-
tion with a PIN known only to yourself. The
system PIN must be entered when, for exam-
ple, registering/de-registering a handset to/
from the base or when restoring the default
settings.
Changing the system PIN
You can change the 4-digit system PIN set on
the base (default setting: 0000) to a 4-digit
PIN that only you know.
Gigaset A510A: setting a system PIN enables
remote operation of the answering machine
¢ page 39.
¤ Settings ¤ System ¤ System PIN
§Menu§
~
~
Resetting the system PIN
If you have forgotten your system PIN, you
can reset the PIN to the original code 0000
using the button on the base. This will also
reset other settings; see the section enti-
tled "Resetting the base to the default set-
tings".
Enter the current system PIN
§OK§
and press .
Enter your new system PIN and
§OK§
press .
Resetting the base to the
default settings
When restoring default settings:
u Individual settings are reset
u All lists are deleted
u Eco Mode is deactivated
The date and time are retained.
Please note
The answering machine is ready for use
approx. 15 seconds after the base has
been connected or reset.
Resetting the base via the menu
When resetting via the menu
u Handsets are still registered
u The system PIN is not reset.
¤ Settings ¤ System ¤ Base Reset
§Menu§
§OK§
Press the display key.
Resetting the base using the
button on the base
When resetting the base using the button on
the base
u All handsets are de-registered and
u The system PIN is reset to the original
code 0000
Carry out the following steps:
¤ Remove the mains cable from the base
¤ Hold down the registration/paging key
on the base (¢ page 5) and reconnect
the power cable to the base at the same
time. Hold the key down for at least 5 sec-
onds.
Please note
All handsets are de-registered and must
be re-registered. All settings are reset to
the default settings.
Base settings
47