Network Setup - Intellinet Network Solutions 524803 Guía De Instalación Rápida

1. Connect your 3G / 3.5G USB modem to the USB port on the top
panel of the router.
2. Connect your computer to the Ethernet port
on the right side panel of the router. NOTE:
It's recommended that you use a cable
connection through the Ethernet port for the
router's initial configuration. The PWR/CHG
LED should light green and the Ethernet
LED should be on if the computer or other
network device connected to the router's Ethernet port is turned on and connected
properly.

NETWORk SETUP

The following steps are for the preliminary network setup of the router using a Web
browser, which will make the router operational and ready for advanced configuration
based on procedures in the user manual. NOTE: Screen images of other Windows
operating systems are similar. Some screen images have been modified to fit the
format of this guide.
1. Set your computer to
obtain an IP address from
a wireless router: Click
"Start" (usually located in
the lower-left corner of your
PC desktop), then Control
Panel; double-click Network
Connections, then double-
click Local Area Connection;
and lastly, on the Local Area
Connection Status screen,
click "Properties. "
USB port
Modem
English
3