Suaoki U7 Manual Del Usuario página 6

Note:
1. Do not charge the product immediately right after jump-starting your car.
2. Please disconnect the battery clamps from the product before charging it.
3. Do not charge the product continuously for more than 10 hours.
4. Do NOT charge the jump starter via a USB-A power adapter from
non-normalized manufacturers. Otherwise, the charging may be limited
or could not be fully charged.
Jump starting a 12V vehicle
Note:
Please make sure the power level is above 50% before using the jump
start function.
DO NOT use the jump starter to start the vehicle continuously. Allow at
least 30 seconds of resting time for the jump starter before giving it
another try.
Step 1: Insert the EC5 plug of the battery clamp to the jumping port of
the product. If the built-in battery of the jump starter works normally, the
red and green indicator lights would flash alternately. If the battery is not
working normally, the red indicator light would be on and the buzzer
would beep.
Step 2: Connect the red battery clamp to the positive terminal of the
battery (+). Connect the black clamp to the negative terminal of the
battery (-). If the red and black clamps are connected correctly, the green
indicator light would be on (solid). This means that you can start your
vehicle.
EN-3