Suaoki U7 Manual Del Usuario página 7

However, if the buzzer beeps, the clamps are connected in reverse order.
If buzzer beeps even though the clamps are correctly connected, the
vehicle's battery is severely damaged.
If the red and green indicator lights keep flashing alternately (the
buzzer may beep), you need to use force start function (check 'Force
Start Function' section for more details).
If the red indicator light stays on and the buzzer beeps, you need to
use force start function (check 'Force Start Function' section for more
details).
Step 3-a: Jump starting your vehicle. Once the green indicator light is
on (solid), you need to start your vehicle within 30 seconds.
Step 3-b: Force starting your vehicle.
Note: Short circuit protection will be disabled when using the force start
function. Make sure that the black clamp and the red clamp are
connected correctly before using this mode.
Q: When to use force start function?
You would need to use this function when the voltage level of your car
battery is below 1 Volt or when you want to test the jump starter's
functionality with no battery in the car.
Q: How to use force start function?
1. Long press the force start button for 3 seconds. The green indicator light
would be on.
2. Once the green indicator light is on, you need to start your car within 30
seconds.
3. When the car is started successfully, the red indicator light would be on.
Disconnect the jump starter from the car battery.
Step 4: After your vehicle is started successfully, you need to
disconnect the clamps from the vehicle's battery immediately.
Step 5: Remove the EC5 plug of battery clamp from the jump starting
port.
EN-4