Worx Professional WU529 Manual Del Usuario página 8

cause kickback.
SAFETY INSTRUCTION FOR CIRCULAR SAW WITH INNER
PENDULUM GUARD
1 Check lower guard for proper closing before each use. Do not
operate the saw if lower guard does not move freely and close
instantly. Never clamp or tie the lower guard into the open
position. If saw is accidentally dropped, lower guard may be bent.
Raise the lower guard with the retracting handle and make sure it
moves freely and does not touch the blade or any other parts, in all
angles and depths of cut.
Check the operation of the lower guard spring. If the guard and
2
the spring are not operating properly, they must be serviced before
use. Lower guard may operate sluggishly due to damaged parts,
gummy deposits, or a build-up of debris.
Lower guard should be retracted manually only for special cuts
3
such as "plunge cuts" and "compound cuts". Raise lower guard
by retracting handle and as soon as blade enters the material, the
lower guard must be released. For all other sawing, the lower guard
should operate automatically.
4 Always observe that the lower guard is covering the blade before
placing saw down on bench or floor. An unprotected, coasting
blade will cause the saw to walk backwards, cutting whatever is in
its path. Be aware of the time it takes for blade to stop after switch is
released.
All manuals and user guides at all-guides.com
8
Symbols
To reduce the risk of injury, user must read instruction
manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Indoor use only
Do not expose to rain or water
Do not burn
Do not dispose of batteries. Return exhausted batteries to
your local collection or recycling point