SOMFY SITUO io Serie Manual De Instalación Rápida página 13

3.1 Programming on a Somfy remote-controlled socket
▶ Adding a remote control (B) using a pre-programmed remote control (A)
1. On the 5-channel remote control A, select the channel which controls the products you want to add to remote
B
control : press the channel selector button as many times as necessary for the pre-programmed channel.
2. Use a fine-tipped object to press the PROG button on the back of this same remote control A. The indicator
lights on the associated appliances will flash.
3. On 5-channel remote control B, press the channel selector button as many times as necessary until the
indicator lights show the channel to be added.
4. Use a fine-tipped object to press the PROG button on the back of this same remote control B. The indicator
lights on the appliances to be associated will come on continuously, and then go out. The channel is pro-
grammed on the new remote control B.
5. If necessary, repeat this procedure with the other channels on remote control A.
1
Remote control already programmed (A)
This procedure requires a good knowledge of your installation.
For example, to add 2 roller shutters associated with channel 1 of remote control
if you have already programmed one of these 2 roller shutters on channel 5 of remote control B, the shutter already
programmed will be deleted and the other one will be added.
We therefore advise you to add your products step by step, with an individual control, to avoid any deprogramming
error.
EN - Installation and operating manual 1-channel - 5-channel variation remote controls - SOMFY
PROGRAMMING YOUR REMOTE CONTROL
2 4
New remote control (B)
A to channel 5 of remote control B,
3
5
5