Changing Temperature Unit Of Measure; Uploading From A Usb Drive - Ovention Matchbox M1313 Manual De Instalación Y Operación

English
6. When the setpoint temperature changes are complete,
touch EXIT aND SaVE to return to the admin mode
screen.
• If programming is complete, touch BaCk to return to
the main Recipes screen.

Changing Temperature Unit of Measure

Use the following procedure to change the temperature unit of
measure between fahrenheit and celsius. This procedure
requires access to password-protected screens and should be
performed by authorized personnel only.
1. From the main Recipes screen, touch the "up" arrow.
• a password keypad will appear on the touchscreen.
2. Input the password using the keypad, and touch ENTER.
• The admin mode screen will appear on the
touchscreen.
3. Touch maINT to access the maintenance mode screen.
Touch to access
Set Time/Date
screen.
Touch to access
Sound Settings
screen.
Touch to access
Diagonostics Mode
screen.
maintenance mode Screen
4. Touch CONFIG on the maintenance mode screen. The
Oven Configuration screen appears.
5. Touch TEmP mODE on the Oven Configuration screen to
toggle the unit of measure between fahrenheit and celsius
Touch to toggle between
fahrenheit and celcius.
Maintenance Mode screen.
Oven Configuration Screen
Form No. OVmm-0116
All manuals and user guides at all-guides.com
Touch to access
Oven Configuration
screen.
Touch to return to
Admin Mode screen.
Touch to return to

Uploading from a USB Drive

Use the following procedure to upload pre-programmed menu
items or firmware updates from an external USB drive. This
procedure requires access to password-protected screens and
should be performed at oven startup by authorized personnel only.
NOTE: USB drive must have a capacity of 4 GB or less.
1. move the Standby switch up to the "On" position.
• The touchscreens will energize. One touchscreen shows
the available setpoint temperatures. The other
touchscreen shows the name of the oven and current
software version.
2. Remove the cover from the USB port above the Standby
switch, and insert the USB drive into the port.
3. Touch the upper left-hand corner on the right touchscreen.
• a password keypad will appear on the touchscreen.
LEFT TOUCHSCREEN
Touch here to access password keypad
followed by the Admin Mode screen.
Startup Screens
4. Input the password using the keypad, and touch ENTER.
• The admin mode screen will appear.
5. Touch USB to access the USB Functions screen.
Touch to upload
touchscreen
firmware update.
Touch to upload
relay firmware
update.
USB Funtions Screen
6. Touch the desired function to begin the corresponding
upload.
• Select the upload file from the list that appears.
• a screen will appear to indicate that the upload is in
progress.
• When the upload is complete, the oven will restart.
7. When the startup screens reappear, remove the USB drive
from the USB port, and replace the port cover.
8. Perform the normal "Startup" procedure at the beginning of
this section to use the oven.
13
OPERATION
RIGHT TOUCHSCREEN
7.12L02 - 5.14
Touch to upload
pre-programmed
menu items.