Uline H-7149 Manual De Instrucciones página 5

Left Hand
Outside End
Plastic Buttons
x 16
Double-faced
Tape x 6
Shelf (1" Flange) x 3
1. Unpack carton and identify all parts. Peel off
protective film from face side of all flat steel parts.
2. Position the two outside end panels (flange side up)
and the three back panels (tab side up) as shown
on a smooth, non-marring surface. Bottom back
panel has wire cutouts on bottom; top back panel
has a 45-degree flange on the back. (See Figure 12)
3. Lift up one side of the bottom back panel and insert
tabs through the lower slots in the adjacent end
panel. Repeat with other side. Then do the same
with the middle and top back panels. The lower
edge of the middle back panel will slightly overlap
the upper edge of the lower back panel; and
the lower edge of the top back panel will slightly
overlap the upper edge of the middle back panel.
(See Figure 12)
PAGE 5 OF 21
50 SLOT SORTER WITH RISER PARTS
Panel
Bottom Back
Panel
50 SLOT SORTER WITH RISER ASSEMBLY
Right Hand
Inside End
Panel
Left Hand
Inside End
Panel
Middle Back
Panel
Figure 12
Back Panel
Right Hand
Outside End
Panel
Top Back
Panel
Shelf (1/2" Flange) x 8
Outside End Panel
Divider x 8
0621 IH-7149