50 SLOT SORTER WITH RISER ASSEMBLY CONTINUED
10. Repeat steps seven through nine to create the
second tier of pockets in the sorter. Start by installing
the top shelf of the first tier, which has no divider slots
and a 1" front flange; this also acts as the bottom
shelf for the second tier.
11. Position the top shelf (1" front flange and no divider
slots) over the top row of tabs on the back panel
and with its tabs through the loops on the inside end
panel, and set it carefully in place.
12. Remove backing from double-faced tape previously
attached to bottom of sorter. Lower sorter onto
table and set in place. Tape will prevent sorter from
moving on table. (See Figure 17a)
Figure 17a
PAGE 7 OF 21
1-800-295-5510
uline.com
0621 IH-7149