Publicidad
Idiomas disponibles
Idiomas disponibles
3. Place tabletop (4)
upside down on a
smooth, non-marring
surface. Insert four
camlocks (B) into
corresponding holes
on leg panels
(1, 2 and 3). Insert four
camlock pins (A). With
two people, place the
assembled base on
the tabletop (4). Turn
each camlock (B)
clockwise until it locks.
Cover each camlock
(B) with a deep
camlock cap (G).
(See Figure 2)
4. Attach an L-Bracket (E) to each side of the center
leg (1) and secure to tabletop (4) using four #4 5/8"
screws (F) per bracket. Tighten screws with Phillips
screwdriver. (See Figure 3)
5. Attach an L-Bracket (E) to leg panel (2) and secure
to tabletop (4) using four #4 5/8" screws (F). Tighten
screws with Phillips screwdriver. Repeat to attach leg
panel (3) to tabletop (4). (See Figure 3)
NOTE: Ensure two L-Brackets connect center
leg (1) to the tabletop (4) and one L-Bracket
connects each leg panel (2 and 3) to the
tabletop (4).
NOTE: L-Bracket holes can be started with drill
(optional).
Figure 3
3
1
PAGE 2 OF 6
ASSEMBLY CONTINUED
Figure 2
2
B
G
A
4
3
2
1
4
2
4
F
1
4
E
6. Mount floor glides (D) on center leg (1), and leg
panels (2 and 3). Floor glides (D) can be adjusted to
compensate for uneven floors. (See Figure 4)
7.
With two people, turn table over and set it upright.
(See Figure 5)
Figure 5
1-800-295-5510
uline.com
Figure 4
D
3
2
1
4
1
0421 IH-5673
Publicidad
