Programming The Speed Controller Parameters Without Using The Programmer - Multiplex ROXXY 900 Serie Manual De Uso

5. Programming the speed controller parameters without
using the Programmer
There are i ve programmable parameters.
This is the procedure for entering programming mode:
1. Connect the speed controller as shown in the wiring
diagram (but don't connect the drive battery).
2. Switch the transmitter on, and move the throttle stick to
the "forward" position.
3. Connect the drive battery to the speed controller.
4. The controller emits a brief series of beeps to coni rm
connection.
5. After about ten seconds you will hear a double series of
beeps, followed by a triple series of beeps after a further
three seconds.
Parameter type
Battery type
Parameter 1
Parameter 2 Direction of motor rotation
Parameter 3 - Brake ON/OFF (AIR)
- Brake ON/OFF (HELI)
Model type AIR/HELI
Parameter 4
Parameter 5 Model type BOAT/CAR
To change the parameter you must i rst move the throttle
stick from the "forward" position to the "stop" position, and
leave the throttle stick in the "stop" position for at least three
seconds.
Parameter type
Battery type
Direction of rotation
Brake (AIR)
Governor (HELI)
Reverse (CAR, BOAT)
Model type (AIR/HELI)
Model type (BOAT/CAR)
The change is stored by moving the throttle stick from the
"stop" position to the "forward" position.
www.modellmarkt24.ch www.modellmarkt24.ch
The speed controller now emits a continuous series of single
beeps and LED l ashes to coni rm that Parameter 1 has been
selected.
The parameter to be programmed is selected using the fol-
lowing sequence of throttle stick positions: move the throttle
stick briel y from the "forward" position to the "stop" position
then back to the "forward" position again. The controller now
emits continuous double beeps and LED l ashes to coni rm
that Parameter 2 has been selected. Repeat the sequence of
throttle stick movements described above in order to select
Parameters 3, 4 and 5.
The actual parameter is altered by moving the throttle stick
rapidly from the "stop" position to the "forward" position and
back.
LED ON
Beep every 2 Sec.
LiPo
Normal
OFF
OFF
OFF
AIR
BOAT
The i nal step is to disconnect the drive battery; this concludes
the process and adopts the programmed settings. The speed
controller is now programmed, and is ready for use.
Beep LED
1 x 1 x
2 x 2 x
3 x 3 x
4 x 4 x
5 x 5 x
LED l ashes
Beep every 0,5 Sec.
NiCD/NiMH
Reverse
ON
ON
ON
HELI
CAR
13