Characteristics, Protective Functions; Programming Example - Multiplex ROXXY 900 Serie Manual De Uso

5.1. Characteristics, protective functions

BEC Integral receiver power supply.
POR Power-on guard, prevents the motor starting accidentally.
PCO Low voltage cut-off. The speed controller switches the motor off in good time when the battery is nearly
discharged, in order to reserve sufi cient battery capacity for controlling the model, and in order to avoid
deep-discharging the drive battery (optionally for NC/NiMH or LiPo battery).
hec High pulse frequency for i ne control of motor speed; also avoids premature magnet degradation.
Super Programming System
SPS
Cool Power FET New generation of transistors
WP Splashproof construction (Water Protect)
Hec High motor frequency
Opto Galvanic separation between motor interference and receiver.
RX-Filter Switches the speed controller off if the transmitter signal is absent or invalid.
TOP Double overload protection (Thermal Overload Protection)
TP Thermal fuse (Thermal Protection)

5.2. Programming example

The following example elucidates the method of setting up the speed controller to match individual stick positions,
followed by the programming of the model type: AIR and brake ON.
Programming the stick positions
1. Switch the transmitter on, and move the throttle stick to the "forward" position.
2. Connect the drive battery to the speed controller (unit emits a brief beep).
3. After about ten seconds a double series of beeps confirms that it has detected the "stick forward" position.
4. Move the throttle stick to the "stop" position. A brief series of beeps confirms that the controller has detected the "stop" position.
5. Disconnect the drive battery from the speed controller.
Programming the controller parameters
1. Switch the transmitter on, and move the throttle stick to the "forward" position.
2. Connect the drive battery to the speed controller (unit emits a brief beep).
3. After about ten seconds you will hear a double series of beeps, followed by a triple series of beeps after a further three seconds.
4. The controller is now in programming mode for Parameter 1 (continuous single beeps and LED flashes).
5. Select Parameter 4 by moving the throttle stick four times from the "forward" position to the "stop" position and back to the
"forward" position again (continuous quadruple beeps and LED flashes).
6. To change the parameter you must first move the throttle stick from the "forward" position to the "stop" position, leaving the
throttle stick at the "stop" position for at least three seconds.
7. Select the "Air" mode (beep sounds/LED lights up every two seconds).
8. The change is stored by moving the throttle stick from the "stop" position to the "forward" position.
Setting Air Brake On
1. When you have stored the setting as described above, the speed controller returns to parameter select: Parameter 4.
2. Select Parameter 3 by moving the throttle stick four times from the "forward" position to the "stop" position and back to the
"forward" position again (continuous triple beeps and LED flashes).
3. To change the parameter you must first move the throttle stick from the "forward" position to the "stop" position, leaving the
throttle stick at the "stop" position for at least three seconds.
4. The controller now displays the currently set brake function: Air Brake ON (beep sounds / LED flashes every 0.5 seconds) or
Air Brake OFF (beep sounds/LED lights up every two seconds). If you wish to change the parameter, move the throttle stick
rapidly from the "stop" position to the "forward" position and back.
5. The change is stored by moving the throttle stick from the "stop" position to the "forward" position.
6. Disconnect the speed controller from the drive battery.
14
www.modellmarkt24.ch www.modellmarkt24.ch