Programming In Detail - Multiplex ROXXY 900 Serie Manual De Uso

7. Programming in detail

1. Battery Type
Use the DEC or INC button to set the desired battery type.
When you have selected the new battery type you may i nd
that the previously set "CUT OFF VOLTAGE" and "CUT OFF
TYPE" parameters have changed. The DEC and INC buttons
are always used to set the modes.
2. Cut Off Voltage
The Cut Off Voltage varies according to the battery type you
have set. If you have selected a LiPo battery, the speed con-
troller switches off at 3 V per cell in Auto mode; if you have
selected a NiCd pack, the unit switches off at 5.5 V (variable
cut-off type). However, you can set the value yourself using the
DEC and INC buttons; the range extends from 4.5 V to 33.0 V.
3. Cut Off Type
In Cut Off Type mode you can select the cut-off method when
battery voltage falls to the set threshold. The options are "Soft
Off" or "Hard Off". Use the DEC and INC buttons to set the modes.
4. Motor Direction
In Motor Direction mode you can select the direction of rotation
of your motor: the two options are normal and reversed.
5. Advance Timing
Advance Timing is an alternative term for motor timing. This
mode alters the advance of the rotational i eld, which has a
similar effect to "advancing the ignition point". In general terms
a setting of 8° is suitable for most motors. If you wish to use a
special set-up for your motor, we recommend the following ranges
of values: 0° to 10° for in-runner motors, and 15° to 25° for
out-runner motors.
16
www.modellmarkt24.ch www.modellmarkt24.ch
6. Acceleration
In Acceleration mode you can set how fast the controller runs
up to maximum speed. This is important if the throttle function
is assigned to a switch, as it determines the delay, i.e. the
speed with which the motor ramps up to "full-throttle".
Example: Lowest acceleration or Highest acceleration.
Variable parameters:
Lowest / Low / Normal / High / Highest, set using the DEC
and INC buttons.
7. Start Power
In the Start Power menu you can set the level of power (torque)
which the motor produces initially, i.e. from a stand-still. If you
are using the controller in a model helicopter, the value should
be small in order to avoid premature gear wear. The available
values are Lowest / Low / Normal / High / Highest.
8. Air Brake Type
In Air mode (model aircraft) it is possible to adjust the effect
of the motor brake, and thereby determine whether the motor
comes to a halt gently (soft) or abruptly (hard). The available
options are Slow / Normal / Fast, and can be selected using
the DEC and INC buttons.
9. Air Brake On/Off - Air mode only
This menu point is used for switching the motor brake on or off.