Uline H-1119 Manual De Instrucciones página 5

DISPLAY – MOUNTING AND INSTALLATION CONTINUED
PLUGGING DATA CONNECTOR INTO DISPLAY
(CONTINUED)
3. Mark which push button is plugged into the (+) and
(–) jacks:
(+) Push button advances the numbers.
(–) Push button goes back to previous numbers.
WIRING AC POWER SUPPLY
WARNING! Do not connect display to power
until all push button and power connections
are complete. Serious electrical shock, injury
or death may result.
1. Cut a length of electrical wire that will reach from
the electrical outlet to the display location.
2. Strip wire ends about 1/2". (See Figure 12)
3. Loosen both screws on the bottom of the AC power
supply.
4. Attach one wire to each screw post underneath the
metal plates. Tighten screws to secure wires.
(See Figure 13)
Figure 12
WIRING AC POWER SUPPLY TO POWER CONNECTOR
1. The power connector has two ports. Loosen both
small screws using the mini flathead screwdriver.
2. Insert one wire end into each port. Tighten screws to
secure wires. (See Figure 14)
Power Connector
PAGE 5 OF 18
Figure 13
Electrical Wire
Figure 14
3. Plug the power connector into either of the two
power receptacles located on the back of the
display. (See Figure 15)
4. Plug the AC power supply into the nearest outlet.
SETUP
SETTING SOUND TONE AND VOLUME
Use a mini screwdriver to change the tone and volume
switches on back of the display. (See Figure 16)
Set the sound tone with switches 1-2:
• No sound: 1-OFF, 2-OFF
• Single tone: 1-OFF, 2-ON
• Double tone: 1-ON, 2-OFF
• Triple tone: 1-ON, 2-ON
Set the volume with switches 3-4:
• Low volume: 3-OFF, 4-OFF
• Medium volume: 3-ON, 4-OFF
(recommended in most cases)
• High volume: 3-OFF, 4-ON
• Highest volume: 3-ON, 4-ON
Power Connector
Figure 15
Figure 16
0421 IH-1119