Hitachi AXM10E Guía De Operación página 47

• RESET
If operations or displays of this unit are at fault:
Many functions of this unit are controlled by microcomputers. Make the units in
standby mode and then press the reset switch when operations or displays are still at
fault in spite of pressing any buttons. There is also need to set stations again because
pressing the reset switch makes the preset stations lost.
TUNER SECTION
TUNER AERIALS
• For FM, connect the provided FM feeder antenna (see page 18).
• For MW, adjust the position of AM loop antenna (see page 17).
A. STEREO/MONO button (using the remote control unit)
- Auto mode:
When listening to an FM stereo broadcast, set the unit to this mode by pressing the
ST/MONO button. The STEREO indicator lights when the FM stereo broadcast is
received.
- Mono mode:
When the FM stereo reception is noisy, set the unit to MONO MODE by pressing the
ST/MONO button.
- Seek tuning:
Press the UP or DOWN button for one second or more. The unit enters the seek
tuning mode to tune in the nearest station automatically, so the broadcast can be
heard.
- Manual tuning:
Each time the UP or DOWN button is pressed, the unit steps through the current
frequency band. Tuning is done in steps of 50 kHz for FM and 9 kHz for MW.
Note:
• When seek tuning to the required station is not possible because the broadcast
signal is too weak, press the UP or DOWN button momentarily to perform manual
tuning.
• When the power is set to the STANDBY, or another mode (CD or AUX) is selected,
the last tuned frequency is stored in memory. When the power is switched on again
and BAND button is pressed, the same station will be turned on.
B. Auto preset tuning (using the remote control unit)
This will automatically store any broadcasting stations with strong signals into the
memory (Max. 10 for FM and 10 for MW)
• Press the AUTO PRESET button for more than 2 seconds. The frequencies of
stations broadcasting signals can be stored in memory automatically in the order of
increasing frequency.
046-050(Eng) AX-M10E
All manuals and user guides at all-guides.com
Bottom view
47
47
Press RESET switch inside
the unit with a cocktail stick.
Do not use a metal stick.
7/26/02, 5:19 PM
English