After Each Use; Every Six Months - Remington HC-5200 Guía De Uso Y Cuidado

Cleaning and Maintainence
Your clipper is fitted with high qual-
ity blades. To ensure long lasting
performance of your clipper, clean
the blades and unit regularly. Always
keep the attachment guide comb on
the trimmer blade.
NOTE: Ensure that the hair clipper is
turned off when cleaning.

After each use

■ Brush the accumulated hair from
the blades. Do not submerge the
clipper in water.
■ To clean unit, wipe with damp cloth
and dry immediately.
Click N' Wash System
Only models HC-5350, HC-5355 and
HC-5356.
The Click N' Wash system is designed
to maximize the efficiency of
washable cleaning.
■ Click the buttons that are located
on the sides of the hair clipper
head. The blades will slide out
allowing the blade to be easily be
cleaned under the tap.
■ Once the blades are cleaned, lock
them back into place by pushing
the blade set towards the clipper
body. You will hear a "click" when
blades are locked into place.
■ Do not run the entire unit under the
tap, only the blade set is meant to
be rinsed in water.
24
■ Add oil, place a few drops of cutter
or sewing machine oil onto the
blades after rinsing with water.

Every six months

■ At regular intervals the blade set
should be removed and cleaned.
1. Remove the 2 screws retaining the
fixed blade with a screwdriver.
2. Brush out hairs from between the
blades with soft cleaning brush. Do
not remove the lubricating grease
from the blades. It is not necessary
to remove the small moving blade
from the unit.
3. If the moving blade has been
removed this can be re-fitted by
slotting the coated blade holder
over the pin in the centre of the
interior product head. The groove
on the coated blade, just below the
teeth, rests on a metal plate at the
opposite side to the screw holes.
The fixed blade is fitted with the
raised profile pointing outwards and
fixed with the 2 screws.
■ NOTE: If the blades are not
correctly aligned then cutting
efficiency will be impaired.
■ Place a few drops of cutter or
sewing machine oil onto the blades.
Wipe off excess oil.