Control Panel Description - TATRA TW.F50+DR Manual Del Usuario

EN
•
If the device is to be used through a cable with a plug, then it must be connected to a
properly installed outlet with a single protective contact. It is forbidden to use any
extension cords or sockets with multiple sockets. To disconnect the power cable, do not
pull the cord. Always hold the plug socket.
•
If the plug cable is located in the aisles, it may cause injury or damage to your device.
Place the device with that in mind.
•
If the device is delivered without cable, then you need to lay a TTR electrical cable with
a cross-section of 5x2.5 mm and leave at least 3 spare meters of the cable to connect
the devices.
CAREFUL! ELECTRICAL SHOCK HAZARD!
In case of improper installation and electrical connection, the device may cause
injury.
OPERATION
The industrial dishwashers are designed for economical and accelerated washing of
dishes in large quantities. These dishwashers are different from domestic dishwashers.
The performance of industrial dishwashers also depends on external factors. Such as the
quality of detergents used, inlet water temperature, inlet water pressure, water hardness, etc.
For a long life of your dishwasher and good washing results, ensure monitoring the
calcium level in water. If water is calcified, provide a water softener.
4.4.

Control panel description

Dishwasher control panel: TW.F50
Dishwasher control panel: TW.H50
OFF position
Position for
1 program
Position for
2 program
Position for
3 program
Position for
4 program
34
If the control knob is in OFF position, the divice is
turned off. To turn on the dishwasher, switch the
knob to the program position.
Washing for 60 sec.
Washing for 90 sec.
Washing for 120 sec.
Washing for 180 sec.