Using The Dishwasher - TATRA TW.F50+DR Manual Del Usuario

Position for pumping
START button
ON indicator
Heating indicator
Cycle indicator
4.5.

Using the dishwasher

Before using the dishwasher, make sure that water and electricity are connected
properly.
Then move the control knob from OFF to any program position.
When you start the dishwasher for the first time, it will automatically check the water
level. If the tank is empty or the water level is insufficient, the dishwasher will add the amount
of water to the required level. During this period, the cycle indicator blinks at an interval of 0.8
seconds. Upon completion of the water intake process, the cycle indicator will turn off and the
heaters will start working. If the water intake process continues for more than 5 minutes, the
cycle indicator will give a signal, blinking at an interval of 0.3 seconds.
When water reaches the required level, the boiler starts first, and then the boiler heater.
Before washing starts, please, wait while the heaters heat up water. The dishwasher takes 30-45
minutes at average to heat up completely cold or just obtained water varies depending on the
water temperature at the entrance and takes 30-45 minutes at average. When the rinsing water
temperature in the boiler reaches 85°C, a green indicator turns on that means the machine is
ready for use.
To use the dishwasher after heating up, place the basket in it and close the door. As for
TW.H50 model, the washing will start according to the specified program after closing the door.
As for TW.F50 models, close the door and keep the START button pressed for 1 second to start
washing. While the program is active, the cycle indicator blinks at intervals of 0.8 seconds. When
washing is complete, rinsing starts automatically in 5 seconds.
Dishwasher has a sanitary rinse function. The machine works until the rinsing water
temperature reaches 85°C. If this temperature is not reached during the washing cycle, the
machine will automatically extend the washing time. When the rinsing water temperature reaches
85°C, the machine washes for another 10 seconds and then starts rinsing. This function ensures
that rinsing is done at 85°C in accordance with the requirements of the hygiene standards of
Hazard Analysis and Critical Control Points.
In the case that the temperature of the rinsing water will not be able to reach 85°C
within 8 minutes, the dishwasher will carry out rinsing at the current temperature of the water
and complete the cycle of the program. But when such a situation occurs, the cycle indicator
blinks at an interval of 0.3 seconds and gives the user a signal.
When the door is opened during washing, the washing process stops automatically.
When the door is closed, the program continues from the moment it has been stopped. To cancel
washing, press and hold the START button to reset the washing program.
To start pumping, switch the control knob to this
position and press START button. (It is active only
for models with drain pump)
Used to activate washing or pumping in TW.F50
models. Used to start pumping in TW.H50 models
equipped with a drain pump.
An indicator lamp that shows if the dishwasher is on.
An indicator lamp that shows if the boiler
temperature has reached 85°C
An indicator lamp that shows the program cycles and
errors.
EN
35