Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION

Mounting
The enclosure is prepared for
the inlet of wires from the
raceway to the wall (remo-
ving the special walls on the
right upper part see picture)
from under floor pipe or
flush-mounting box, thanks
to the special opening seated
on the base. The detector can
be installed directly on the
wall or into AVE flush-moun-
ting rectangular boxes codes:
2503, 2503MG, or 251CG3
with inner slots and distance
between centres of 83.5 mm, or into AVE flush-mounting round boxes
codes: 2501, 2501E, 2502 or 251CG with inner slots and distance bet-
ween centres of 60 mm.
Overall dimensions
TEST
Where installing the device:
Install the detector as follows:
– 2-4 metres from the gas run equipment (boiler, kitchen, etc.)
– Possibly in every room containing a gas appliance.
– In buildings with more than one floor, for better detection, one device
for every floor.
ALARM
Sostituire nel:
Replace in:
154
94
CEI EN 50194
TIPO A
IMQ-CIG
43
21

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Rg1-gRg3-m

Tabla de contenido